Cabinet Door; Changing The Door Direction - V-ZUG Komfort 60i Installation Instructions Manual

Cabinet door

u Check the wall thickness of adjacent cabinets: It must be
min. 16 mm.
u Align the cabinets with a spirit level and a try square. If
necessary level them by putting something underneath
them.
u Ensure that the floor and the side panels of the cabinet
are at right angles to each other.
6 Cabinet door
- A door is required for the kitchen furniture.
- The door must be at least 16 mm and maximum 19 mm
thick.
There must be a gap of at least 3 mm between the door
-
and the cupboard door above (if there is one).
The width of the cabinet door depends on the style of the
-
kitchen and the size of the gap between the cupboard
door panels. Normally a vertical gap of 3 mm should be
left between the cabinet doors.
If there are more cupboards the upper edge of the
-
cabinet door should be at the same height as the doors
on the next cabinet.
The cabinet door must be fitted flat with no tension.
-
NOTICE
An excessively heavy unit door can cause potential damage!
If the unit door is too heavy, we cannot rule out damage to
the hinges, which may compromise the use of the unit.
u Before installing the unit door, ensure the door does not
exceed the permissible weight.
Appliance model
Komfort 60i
Freezer V600 8UN

7 Changing the door direction

NOTICE
Risk of damage due to colliding doors!*
If you are installing V-ZUG Side-by-Side (SBS) appliances
next to another appliance:
u Install the appliances so that the doors open outwards.
Switch the door hinges, if necessary.
WARNING
Risk of injury due to the door dropping out!
If the fastening parts are not screwed into place firmly
enough, the door may drop out. This may lead to severe
injuries. What is more, the door may not close and therefore
the appliance may fail to cool properly.
u Screw on the hinges and the ball stud of the soft stop
mechanism firmly to 4 Nm.
u Screw on the bracket of the soft stop mechanism firmly
to 3 Nm.
u Check all of the screws and retighten if necessary.
Note
You can change the direction of the door only if there is
enough room at the top to remove the hinge fixing brackets
and refit them on the opposite side. This is rarely the case
once the unit is installed in the recess.
u Change the direction of the door before the appliance is
installed.
Risk of injury here! Follow the safety notes!
34
Tools required:
Fig. 3
Maximum unit door
weight
10 kg
Risk of injury if soft stop contracts!
u Carefully remove the soft stop mechanism.
u Remove the closing damper: Remove the closing dampers
These instructions apply to a range of models.
Follow this step only if it applies to your appliance.
Choose from one of these options.
Just loosen the screws, do not remove.
Check the screw connection and tighten screws if
necessary.
R
R
2.
Fig. 4
CAUTION
from the ball studs (1), unscrew the bracket (2). Use a
screwdriver to remove the ball studs (3).
* Depending on model and options
3.
T20
1.