Table of Contents
Advertisement
or qualified repair facility and have the
brake system inspected.
- Always keep in mind that after several brake
applications, you will need greater pressure
on the brake pedal to stop your vehicle. Do
not rely on strained brakes to respond with
maximum stopping power in critical situa-
tions. You must allow for increased braking
distances . The extra distance used up by
fading brakes could lead to an accident.
PARK/( ®) Electromechanical parking brake
The warning/indicator
light monitors the elec-
tromechanical parking brake.
If the indicator light -
(USA models)/ .
(Canada models) turns on, the parking brake was
set .
-
(USA models) ,.
(Canada models) Cau-
tion: Vehicle parked too steep
If the indicator light blinks and the message ap-
pears, there is not enough braking power to keep
the vehicle from rolling. The brakes have over-
heated. The vehicle could roll away even on a
small incline .
Press brake pedal to release parking brake
To release the parking brake, press the brake
pedal and press the button ~ or start driving
with starting assist at the same time
c:> page84.
Please release parking brake
To release the parking brake manually, press the
brake pedal and press the button ~ at the same
time. The parking brake only releases automati-
cally if the driver's safety belt is fastened.
mJ
Parking brake!
If the
Iii
indicator light turns on and this mes-
sage appears, there is a parking brake malfunc-
tion . Drive to your authorized Audi dealer or
qualified workshop immediately to have the mal-
;:;:: function corrected.
0
J:
'SI:
,....,
<J:)
Lil
,....,
<J:)
,....,
Instruments
and indicator
lights
- L
Cooling system
•
Switch off engine and check coolant level!
The coolant level is too low .
Do not continue driving and switch the engine
off. Check the coolant level
c:>
page 22 7.
- If the coolant level is too low, add coolant
c:>
page 228. Only continue driving once the in-
dicator light turns off.
•
Coolant temperature too high! Let engine
run with vehicle stationary
Let the engine run at idle for a few minutes to
cool off, until the indicator light turns off .
- If the indicator light does not turn off, do not
continue driving the vehicle . See an authorized
Audi dealer or authorized Audi Service Facility
for assistance .
A
WARNING
- Never open the hood if you can see or hear
steam or coolant escaping from the engine
compartment.
This increases the risk of
burns. Wait until you no longer see or hear
steam or coolant escaping.
- The engine compartment
in any vehicle can
be a dangerous area. Stop the engine and
allow it to cool before working in the engine
compartment.
Always follow the informa-
tion found in c:> page 220.
(0
Note
Do not continue driving if the .
indicator
light turns on - this increases the risk of en-
gine damage.
C:I
Battery
This warning/indicator
light detects a malfunc-
tion in the generator or in the vehicle's electrical
system .
The .
warning/indicator
light illuminates when
you switch on the ignition and must go out after
the engine has started .
•
Alternator fault: Battery is not being charg-
ed
~
15
Advertisement
Table of Contents
