Table of Contents
Advertisement
Audi active
lane assist
Activating and deactivating
Applies to: vehicles with active lane assist
Fig. 107 Turn sign al lever: Active lane assist button
Fig. 108 Windshiel d : Active lane assist camera viewing
window
• Press the
r=;,
fig.
10 7
button to activate or deac-
tivate the system. The indicator light .
or
Pit
in the instrument cluster will illuminate or go
out.
Instrument cluster indicator light
•
Ready: The ind icato r light shows that the sys-
tem is ready to use. The system can now warn
you if you are about to cross a known lane marker
line.
Pit
Not ready: The ind icat or light shows that th e
system is turned on but unab le to send a warn-
ing . This can be due to the following :
- There is no lane marker line .
- The relevant lane marker lines are not detected
(for example , mark ings in a construct ion zone
o r because they are obstructed by snow, dirt,
water or backlighting).
- The vehicle's speed is below the speed needed
to activate it , which is about 40 mph (65 km/
h).
- The lane is narrower than about 8 ft. (2.5 m) or
wide r than 15 ft (4.5 m).
100
- The curve is too sharp.
- The driver's hands are not on the steering
wheel.
{i)
Tips
Make sure the camera's field of view
r=;,
fig.
108
is not obstructed by stickers, de-
posits or anything else. For information on
cleaning, refer to ¢ page 206.
Active lane assist display in the instrument
cluster
Appl ies to : vehicles with active lane assist
Fig. 109 Displ ay: Activ e lane assist is switc hed on and is
warn ing
Fig. 110 Instrument cluste r: Active lane assist is switched
on but hot ready to provide warnings
You can call up the active lane assist display us -
ing the buttons in the multifu nction steering
wheel
r=;,
page 23.
When active lan e assist is switched on, the sys-
tem indicates which lines a re detected by display-
ing solid lines on the left and/or right side of
your vehicle:
Advertisement
Table of Contents
