Specifications - Midea MSXE-10CRDN8 User Manual

TAKE NOTE OF FUSE SPECIFICATIONS
The air conditioner's circuit board (PCB) is designed with a fuse to provide
overcurrent protection. The specifications of the fuse are printed on the circuit
board , such as : T3.15AL/250VAC, T5AL/250VAC, T3.15A/250VAC, T5A/250VAC,
T20A/250VAC, T30A/250VAC,etc.
NOTE: For the units with R32 refrigerant , only the blast-proof ceramic fuse can be
used.
UV-C lamp(Applicable to the unit contains an UV-C lamp only)
This appliance contains a UV-C lamp. Read the maintenance instructions before
opening the appliance.
Do not operate UV-C lamps outside of the appliance.
●
Appliances that are obviously damaged must not be operated.
●
Unintended use of the appliance or damage to the housing may result in the
●
escape of dangerous UV-C radiation. UV-C radiation may, even in small doses,
cause harm to the eyes and skin.
Before opening doors and access panels bearing the ULTRAVIOLET RADIATION
●
hazard symbol for the conducting USER MAINTENANCE, it is recommended to
disconnect the power.
The UV-C lamp can not be cleaned, repaired and replaced.
●
UV-C BARRIERS bearing the ULTRAVIOLET RADIATION hazard symbol should
●
not be removed.
WARNING
WARNINGS FOR PRODUCT INSTALLATION
Installation must be performed by an authorized dealer or specialist. Defective
●
installation can cause water leakage, electrical shock, or fire.
Installation must be performed according to the installation instructions.
●
(In North America, installation must be performed in accordance with the
requirement of NEC and CEC by authorized personnel only).
Improper installation can cause water leakage, electrical shock, or fire.
Contact an authorized service technician for repair or maintenance of this unit.
●
This appliance shall be installed in accordance with national wiring regulations.
Only use the included accessories, parts, and specified parts for installation.
●
Using non-standard parts can cause water leakage, electrical shock, fire, and
can cause the unit to fail.
Install the unit in a firm location that can support the unit's weight. If the chosen
●
location cannot support the unit's weight, or the installation is not done properly,
the unit may drop and cause serious injury and damage.
Install drainage piping according to the instructions in this manual. Improper
●
drainage may cause water damage to your home and property.
For units that have an auxiliary electric heater, do not install the unit within 1
●
meter (3 feet) of any combustible materials.
Do not install the unit in a location that may be exposed to combustible gas
●
leaks. If combustible gas accumulates around the unit, it may cause fire.
Do not turn on the power until all work has been completed.
●
When moving or relocating the air conditioner, consult experienced service
●
technicians for disconnection and reinstallation of the unit.
How to install the appliance to its support, please read the information for
●
details in "indoor unit installation" and "outdoor unit installation" sections .
This appliance contains an UV emitter. Do not stare at the
light source.
04 04