Midea MSXE-10CRDN8 User Manual page 20

6 Mount indoor unit
Put pipes in wall hole
If you installed new connective piping to the outdoor unit, do the following:
If you have already passed the refrigerant piping through the hole in the wall, proceed to Step 4.
●
Otherwise, double-check that the ends of the refrigerant pipes are sealed to prevent dirt or foreign
●
materials from entering the pipes.
Slowly pass the wrapped bundle of refrigerant pipes, drain hose, and signal wire through the hole
●
in the wall.
Hook the top of the indoor unit on the upper hook of the mounting plate.
●
Check that unit is hooked firmly on mounting by applying slight pressure to the left and right-hand
●
sides of the unit. The unit should not jiggle or shift.
Using even pressure, push down on the bottom half of the unit. Keep pushing down until the unit
●
snaps onto the hooks along the bottom of the mounting plate.
Again, check that the unit is firmly mounted by applying slight pressure to the left and the right-hand
●
sides of the unit.
Connecting
cable
Drain
hose
Hook it
Hook it and press down
lightly to secure
18 18
Check that the unit is
firmly mounted