Midea MSXE-10CRDN8 User Manual page 14

199mm(7.8in)
129mm(5.1in)
W
90mm (3.54in)
Indoor unit dimensions(WxH):
1082mm(42.6in)x337mm(13.3in)
NOTE : The wall hole size
The size of the wall hole is determined by the connective pipes. When the pipe size of the gas side
Φ
is 16mm(5/8") or more, the wall hole should be 90mm(3-9/16"). When the pipe size of gas side
Φ
is less than 16mm(5/8"), the wall hole should be 65mm(2-1/2").
Drill wall hole
CAUTION
When drilling the wall hole, make sure to avoid wires, plumbing, and other sensitive
components.
65mm
(2-1/2")
Using a 65mm (2-1/2") or 90mm(3-9/16")
core drill(depending on models )
Wall
Indoor Outdoor
Drill the wall hole
Fig.3.2
Place the protective wall cu in the hole.
603mm(23.7in)
322mm(12.7in)
173mm
(6.8in)
90mm
(3-9/16")
the protective
wall cu
wall hole.
389mm (15.3in)
172mm (6.8in)
52mm (2.05in)
90mm (3.54in)
Indoor unit dimensions(WxH):
1259mm(49.55in)x362mm(14.25in)
Step 1：
Using a 65mm (2.5") or 90mm(3.54")
core drill(depending on models ), drill a
hole in the wall. Make sure that the hole
is drilled at a slight downward angle, so
that the outdoor end of the hole is lower
than the indoor end by about 5mm to
7mm (3/16-5/16"). This will ensure
proper water drainage.
NOTE:
FOR CONCRETE OR BRICK WALLS
If the wall is made of brick, concrete, or similar
material, drill 5mm-diameter (0.2in-diameter)
holes in the wall and insert the sleeve anchors
provided. Then secure the mounting plate to
the wall by tightening the screws directly into
the clip anchors.
Step 2：
Place the protective wall cu in the hole.
This protects the edges of the hole and
will help seal it when you finish the
installation process.
12 12
643.6mm (25.3in)
257mm (10.1in)
332mm (13.05in)
W