Midea MSXE-10CRDN8 User Manual page 23

2 Install drain joint(Heat pump unit only)
NOTE : PRIOR TO INSTALLATION
Before bolting the outdoor unit in place, you must install the drain joint at the bottom of the unit.
Step 1：
Find out the base pan hole of outdoor unit.
Step 2：
Fit the rubber seal on the end of the drain joint that will connect to the
●
outdoor unit.
Insert the drain joint into the hole in the base pan of the unit. The drain joint
●
will click in place.
Connect a drain hose extension (not included) to the drain joint to redirect
●
water from the unit during heating mode.
NOTE : IN COLD CLIMATES
In cold climates, make sure that the drain hose is as vertical as possible to ensure swift water drainage.
If water drains too slowly, it can freeze in the hose and flood the unit.
Seal
21 21
Base pan hole of
outdoor unit