Midea MSXE-10CRDN8 User Manual page 13

2 Drill wall hole for connective piping
Determine wall hole location
Step 1：
Remove the screw that attaches the
mounting plate to the back of the
indoor unit.
Step 2：
Di erent models have di erent mounting plates.
For the di erent customization requirements, the
shape of the mounting plate may be slightly
di erent. But the installation dimensions are the
same for the same size of indoor unit.
See Type A and Type B for example.
Type A
Step 3：
Secure the mounting plate to the wall
with the screws provided. Make sure
that mounting plate is flat against the wall.
Correct orientation of Mounting Plate
Type B
11 11
Step 4：
Confirm the mounting plate you own. Determine the
location of the wall hole based on the position of the
mounting plate.The dotted rectangular box above
shows the size of your product.
101mm(4.0in)
W
65mm (2.5in)
Indoor unit dimensions(WxH):
729mm(28.7in)x292mm(11.5in)
230mm(9.1in)
190mm(7.5in)
W
65mm (2.5in)
Indoor unit dimensions(WxH):
805mm(31.7in)x295mm(11.6in)
244mm(9.6in)
190mm(7.5in)
W
65mm (2.5in)
Indoor unit dimensions(WxH):
835mm(32.9in)x295mm(11.6in)
165mm(6.5in)
106mm(4.2in)
W
65mm (2.5in)
Indoor unit dimensions(WxH):
971mm(38.2in)x321mm(12.6in)
348.4mm(13.7in)
179mm(7.1in)
136mm(5.4in)
403mm(15.9in)
231mm(9.1in)
121mm(4.8in)
418mm(16.5in)
246mm(9.7in)
121mm(4.8in)
527mm(20.7in)
247mm(9.7in)
139mm
(5.5in)