Midea MSXE-10CRDN8 User Manual page 50

SET function
SET
Press the SET button to enter the function setting, then press SET button or TEMP
button to select the desired function. The selected symbol will ash on the display area, press the
OK button to con rm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
*
Breeze Away ( )

[ ]: If your remote controller has Breeze Away button or Air magic button, you can not use the SET
*
button to select the Breeze Away or Air magic/UV lamp feature.
Breeze Away function (some units) :
This feature avoids direct air ow blowing
on the body and makes you feel indulging
in silky coolness.
NOTE: This feature is available under cool,
Fan and Dry mode only.
Air magic/UV-C function(some units)
When the Air magic function is initiated, the
ion generator is energized and will help to
purify the air inside. When the UV function
is initiated, the UV lamp emit UV-C radiation
to help to purify the air inside.
Sleep function
The SLEEP function is used to decrease
energy use while you sleep(and don't
need the same temperature settings to
stay comfortable).
NOTE: The SLEEP function is not available
in FAN and DRY mode.
AP function(some units) :
Choose AP mode to do wireless network
con guration. For some units, it doesn't
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
SET
or
*
Air magic/UV lamp (
.
) Sleep( ) Follow Me(


Follow me function
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
NOTE: Press and hold Boost button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated,
displays for 3 seconds on the screen.
If the memory feature is stopped,
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
48 41
OK
or TEMP
*
) AP mode ( )

, ,
On
, ,
OF
, ,
, ,