Midea MSXE-10CRDN8 User Manual page 49

ECO/GEAR function
following:
ECO
Note:This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote
controller will adjust the temperature automatically
O
to 24 C/75 F, fan speed of Auto to save energy O
(only when the set temperature is less than
O
24 C/75 F). If the set temperature is above O
O
24 C/75 F, press the ECO button, the fan speed O
will change to Auto, the set temperature will
remain unchanged.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternate between electical energy
consumption and set temperature.
Silence function
2s
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
heating capacity. Press ON/OFF, Mode, Sleep, Boost or Clean button while operating will
cancel silence function.
FP function
Press this button 2 times during one second under HEAT Mode and setting temperature of 16 C/60 F
to activate the FP function.
2
The unit will operate at high fan speed (while compressor on) with temperature
automatically set to 8 C/46 F.
GEAR(75%) GEAR(50%)

O
O
Previous setting mode
NOTE: Pressing the ECO button, or modifying
the mode or adjusting the set temperature to
less than 24 C/75 F will stop ECO operation.
Under ECO operation, the set tmeperature
should be 24 C/75 F or above, it may result in
just press the ECO button again to stop it.
50%(up to 50% electrial energy consumption)
47
40
ECO......
O O
O
O

O O