Simrad AP50 Operator's Manual page 19

Simrad
J50
SW 1.3.00
P05 M00 S000
Note !
S
340.
TBY
7
Gyro1
RUDDER
02
ADJUST COMPASS INPUT?
Adjust:
OK? Press or
Gyro2
Heading 018°
Offset +018°
RUDDER
02
Stepper or Synchro
gyro
S 340.
TBY
7
Gyro1
RUDDER
- -
Analog rudder
20221032 / E
Junction unit model
Software version (1), release (3), minor change (00)
Power board revision, Main board revision and Self check
(SW and HW revisions shown are examples only)
After approximately 5 seconds, the system is operative and the
unit that was turned on will show the STANDBY mode
display. Other units in a multistation system will display
"Inactive". Control can be transferred to any single unit by
pressing any of its' mode buttons (except in a Wheelmark
system; see the Introduction on page 1).
A long press (3 sec.) on the
system off and during this time, the alarm will sound.
In an emergency, it is possible, on a multistation system, to turn
OFF the system at any control unit by pressing the
button for 3 seconds (except in a Wheelmark system).
STANDBY mode is used when steering the boat at the helm.
Display information:
• Standby mode
• Current heading from gyro 1: 340.7°
• Rudder angle: 2° to starboard. When there is no rudder
feedback signal (analog rudder drive) the rudder readout
shows – –).
If a stepper or synchro gyro is connected to the autopilot system
via the GI51 Gyro Interface, a display for the heading
adjustment is presented at Power On or at change of compass in
the User Set-up menu. Use the course knob to align the autopilot
read-out to correspond with the gyro heading. Check the
alignment every time the autopilot/gyro is switched on. If two
stepper gyros are connected, both will simultaneously be
aligned. A stepper gyro used as monitor compass will
automatically be aligned to the steering compass.
Press the (PORT) or
Standby mode.
If the inactive symbol
FU50 or while Disengaged) the Control unit must be activated
before alignment by pressing the STBY button.
STBY
(STBY) button switches the
(STBD) button to proceed to
is shown (when powered up from
Operation
STBY
(STBY)
13