Philips PM2528 Operating Manual page 61

66.5,
61
Measurements with the optional data-hold probe PM9263
— Select one of the functions V =, V~,V*,A a, A~, Q 2W or Vpeak
Select a range or the automatic ranging mode.
— Select the HIGH RES mode or the normal resolution mode.
— Select the INT START mode. 7
i
NOTE: Data hold is only possible in the INT START mode.
— Select the INT, EXT or MAN START mode.
— Connect the data hoid probe to the PM2528 as follows:
the DIN plug to the probe input
the VQ. banana plug to the VQ input terminal
the O banana plug to the O input terminal
— Select the most suitable test pin for the probe.
— Connect the probe to zero with the zeroing iead or with a separate banana plug lead.
— Push the slide switch (white ring} on the probe to the RUNNING position (away from the probe tip).
Place the probe tip on the measuring spot and push the slide switch to the HOLD position (towards the
probe tip}. The data on the display is now held (frozen),
Meanwhile the PM2528 carries on measuring and new data will be displayed when the slide switch on the
data hold probe is pushed to the RUNNING position.
Remarks
@ The maximum voltage on the probe tip is 30Vrms.
@ The maximum input current of the probe is 200mA.
@ For technical data refer to page 24.