Philips PM2528 Operating Manual page 33

33
Programming the PM2528 via the !EC-bus interface
Function 1S! description ies
code
|
Vas
ve i
ve i
O2w !
aQaw
|
Ae Function t
AL |
ive) |
vhf
Vpeak i
Vpeak i
Vpeak ¢ |
Range autoranging
(see table) lowest range
highest range
Data ready request SRO disable (no SRQ after a measurement)
SRQ enable (SRO after a measurement)
High speed mode normal speed mode {integration time 100ms)
i
high speed mode {integration time 20ms)
High resolution normal resolution
high resolution
Offset input offset voltage is compensated
input offset voltage is not compensated
NOTE: short-circuit the input terminals 0 and V Qf the i
PM2528.
Select Vz, autoranging, high resolution mode,
Relative reference mode: the measured value is stored in the
memory of the PM2528 after a command 01.
No reiative reference mode.
Start mode internal start
external start via IEC-bus interface
external start via IEC-bus interface or BNC on the
rear of the PM2528
Start command starts a measurement
Group Execute Trigger: starts a measurement