Advertisement
Disassembly/Reassembly
HP 82713A
3-2
3-2.
Note:
3-3.
OPENING THE CASE.
a.
Ensure that the PMS is not plugged into any other
device.
b. Place the unit on the bench so that the three screws
and the bottom case are facing up and the Connector/
Cable Assembly is on your right.
¢c. Using a #2 Posidrive screwdriver, remove the three
screws and lift off the bottomcase.
d. Remove the rear panel.
REMOVING THE LOGIC BOARD.
a. The board facing you is the Logic board.
b. Lift the Logic board out of the topcase with the
Connector/Cable assembly attached.
Do not lay the bare board on a conductive surface.
This may cause shorting between pins and may
damage the board.
It is recommended that the
Logic board be placed on a nonconductive surface,
component side up for troubleshooting.
REMOVING THE CONNECTOR/CABLE ASSEMBLY.
a. Desolder the 20 leads of J1.
Remove J1
from the
Logic board.
b. Loosen the nuts on the cable clamp and remove the
top of the cable clamp.
c.
Lift the cable out of the clamp.
Advertisement
