Advertisement
SERVICING NOTICES ON CHECKING
1. KEEP THE NOTICES
. USE THE DESIGNATED PARTS
The parts in this equipment have the specific characters
of incombustibility and withstand voltage for safety.
Therefore, the part which is replaced should be used the
part which has the same character.
Especially as to the important parts for safety which is
indicated in the circuit diagram or the table of parts as
a AX mark, the designated parts must be used.
3. PUT PARTS AND WIRES IN THE ORIGINAL
POSITION AFTER ASSEMBLING OR WIRING
There are parts which use the insulation material such as
a tube or tape for safety, or which are assembled in the
condition that these do not contact with the printed
board. The inside wiring is designed not to get closer to
the pyrogenic parts and high voltage parts. Therefore,
put these parts in the original positions.
. PERFORM A SAFETY CHECK AFTER
SERVICING
Confirm that the screws, parts and wiring which were
removed in order to service are put in the original
positions, or whether there are the portions which are
deteriorated around the serviced places serviced or not.
Check the insulation between the antenna terminal or
external metal and the AC cord plug blades. And be
sure the safety of that.
Advertisement
