Advertisement
TO CHECK INITIAL SETTING
NOTE: If there is an error in the data, the unit may indicate malfunction.
INSTRUCTIONS
1. Turn on the POWER and press both FF key and CH UP key on the set simultaneously for more than 2 seconds.
The Initial Set Mode indicator will appear and the Address will blink. (Refer to Fig. 1)
2. Press the SET +/- button on the remote control to modify the address and check the data of each addresses are
correct. (Refer to Table 1)
3. After checking, turn off the Power.
(If the wrong data is input)
4. Press the SET +/- button on the remote control to set to the address of the wrong data, then press the ENTER button.
The data will bink. (Refer to Fig. 1)
5. Press the SET +/- button on the remote control to set to the correct data, then press the ENTER button. (Refer to Table 1)
6. Repeat the above steps 4 and 5 and input the data into the each Address.
7. After the data input, turn off the Power.
eae i eee
ADDRESS
DATA
Fig. 1
INT | INT
| ENT | INE | IN) y INT | INT | INI
| pata | oF | oc | oo | Eo | 00 | 00 | 44 | 44 |
Table 1
17
Advertisement
