Advertisement
PREVENTIVE CHECKS AND SERVICE INTERVALS
Tape Running
Guide Post
@:Replace
HE: Clean
CLEANING
NOTE
© After cleaning the heads with isopropyl alcohol, do not
run a tape until the heads dry completely. If the heads
are not completely dry and alcohol gets on the tape,
damage may occur.
1. AUDIO CONTROL HEAD
© Wrap a piece of chamois around your finger. Dip it in
isopropyl alcohol and clean the audio control head by
wiping it horizontally. Clean the full erase head in the
same manner. (Refer to the figure below)
Audio Control Head
2. TAPE RUNNING SYSTEM
© When cleaning the tape transport system, use the gauze
moistened with isopropyl alcohol.
[om | om |
| Ceeanthose parts in
|e
|
ff]
contact with the tape.
|
@
|
|
Clean the rubber, and
=
eee
parts which the rubber
touches.
Replace when rolling
becomes abnormal.
Clean the Head.
3. CYLINDER
© Wrap a piece of chamois around your finger. Dip it in
isopropyl alcohol. Hold it to the cylinder head softly.
Turn the cylinder head counterclockwise to clean it (in
the direction of the arrow). (Refer to the figure below)
NOTE
Do not exert force against the cylinder head. Do not move
the chamois up or down since this can damage the head.
Always use a piece of chamois for cleaning.
Cylinder Head
13
Advertisement
