Main Supply - ESAB Rebel EMP 205ic AC/DC Instruction Manual

4 INSTALLATION
4.4

Main supply

WARNING!
Contact the local electric utility for information about the type of electrical service
available, how proper connections should be made, and inspection required.
The supply voltage should be 230 V AC ±10% or 120 V AC ±10%. Too low of supply voltage
may cause poor welding performance. Too high supply voltage will cause components to
overheat and possibly fail. Contact the local electric utility for information about the type of
electrical service available, how proper connections should be made, and inspection
required.
The welding power source must be:
• Correctly installed, if necessary, by a qualified electrician.
• Correctly grounded (electrically) in accordance with local regulations.
• Connected to the correct size power point and fuse as following table.
NOTE!
Mains supply requirements
This equipment complies with IEC 61000-3-12 provided that the short-circuit power is
greater than or equal to S
the public system. It is the responsibility of the installer or user of the equipment to
ensure, by consultation with the distribution network operator if necessary, that the
equipment is connected only to a supply with a short-circuit power greater than or
equal to S
scmin
NOTE!
Use the welding power source in accordance with the relevant national regulations.
0463 652 101
at the interface point between the user's supply and
scmin
.
- 18 - © ESAB AB 2024