Main Supply - ESAB Rogue EM 190 PRO Instruction Manual

4 INSTALLATION
WARNING!
Secure the equipment - particularly if the
ground is uneven or sloping.
4.3

Main supply

The supply voltage should be 230 V AC ±15%. Too low of supply voltage may cause poor welding
performance. Too high of welding supply voltage will cause components to overheat and possibly fail.
Contact the local electric utility for information about the type of electrical service available, how proper
connections should be made, and inspection required.
The welding power source must be:
• Correctly installed, if necessary, by a qualified electrician.
• Correctly grounded (electrically) in accordance with local regulations.
• Connected to the correct size power point and fuse as indicated in table below.
NOTE!
Use the welding power source in accordance with the relevant local and national regulations.
CAUTION!
Disconnect input power and secure employing 'Lock-out' / 'Tagging' procedures. Ensure input
power line disconnect switch is locked (Lock-out/Tagging) in the 'Open' position BEFORE
removing input power fuses. Connection/Disconnect should be carried out by competent
persons.
1. Rating plate
0447 956 001 - 14 - © ESAB AB 2023