Bean Hoppers
1. Prior to installing the bean hoppers, visually
verify that there is no debris or obstruction
blocking the bean chutes or bean
detection sensors.
3. Install the bean hoppers in any order.
NOTE: Each hopper holds approximately
3.7 lbs (1.68 kg).
4. Hoppers should sit flat when in place correctly.
5. Push the hopper Locking Lever to the back.
This locks the hopper in place and allows beans
to flow down into the grinder.
6. Repeat Steps 3 thru 5 for the remaining
hoppers.
7. The hoppers are ready to be filled with beans.
INITIAL SETUP
1
3
Left
7
12
Chutes Image
4
Center
5
Right