Table of Contents
Advertisement
After 15-20 minutes from starting fire set the damper
in normal work mode. Smoke starts circulating in the
ducts and heat from it will be passed and stored in the
Power Stone core.
When there is a glowing layer of ash, new wood logs
can be inserted. Pull the hot ember to the front of
combustion chamber when inserting new logs so that
the wood is ignited from the front. Place first layer of
wood logs perpendicular to the front. The fire should
burn with bright and lively flames.
Reload size
Chopped wood (diametre of 6-9cm)
Length:<40cm
Normal load size. 2,3 kg /h
When the fire end set the damper in warm retaining
mode, lever pushed in to the limit (for right hand opera-
tion) in order to store more warmth inside appliance.
Choice of fuel
All types of wood, such as birch, beech, oak, elm, ash
and fruit trees, can be used as fuel in the insert. Wood
species have different degrees of density - the more
dense the wood is, the higher the energy value. Beech,
oak and birch has the highest density.
Attention! We do not recommend the use of fuel
briquettes / compact wood in our combustion chambers,
as these products may develop significantly higher
temperature than the combustion chamber can
withstand. Burning briquettes / compact wood is at your
own risk and can cause invalidity of the warranty.
Warning
NEVER use impregnated wood, painted wood,
plywood, chipboard, rubbish, milk cartons,
printed material or similar. If any of these items
are used as fuel the warranty is invalid.
Common to these materials is that they
during combustion can form hydrochloric
acid and heavy metals that are harmful to the
environment, you and the insert. Hydrochloric
acid can also corrode the steel in the chimney
or masonry in a masonry chimney. Also, avoid
burning with bark, sawdust or other extremely
fine wood, apart from when lighting a fire. This
form of fuel can easily cause a flashover that
can lead to temperatures that are too high.
Warning Make sure the insert is not overheated
- it can cause irreparable damage to the product.
Such damage is not covered by the warranty.
Source "Håndbok, effektiv og miljøvennlig vedfyring" by Edvard
Karlsvik SINTEF Energy Research AS and Heikki Oravainen, VTT.
6
fireplace must comply with the current rules and regulations
not responsible for wrongly assembled fireplaces.
Subject to errors and changes.
For the latest updated version go to www.nordpeis.com
Technical info Salzburg L Convection
Salzburg L Convection + 1
Minimum distances to
combustible materials
CO (13% O
)
2
Flue gas temperature
Thermal output
Heat output:
Thermal storage
capacity
Energy efficiency
Nominal heat output
during discharge period
(100%-25%)
Chimney draft
Length of wood logs
Weight
Load size (kg)
Max nr. loads
Loading interval
Nr. burning cycles per
24 hours
GB
Back
20 mm
Side
150 mm
<1500 mg/m³
113 °C
45,1 kWh
162 504 kJ
100% after 4,4 hrs
50% after 16,7 hrs
25% after 27,0 hrs
90 %
2 kW
12 Pa
400 mm
Salzburg L
- ca. 950 kg
Salzburg L+1 - ca.1243 kg
ext. base
35 kg
2,3 kg
5
1 / hour
1
Advertisement
Chapters
Table of Contents
