Table of Contents
Advertisement
Go to VCA → Basic Information and enable Heat Map.
●
Set the storage path first before searching heat map data. For the storage settings, refer to
●
Storage Settings .
Steps
1. Go to VCA → Heat Map → Heat Map Configuration .
2. Check Enable Heat Map to enable the function.
3. Go to Area Settings to draw a detection area.
- Click Draw Area. Draw an area by left clicking the end-points in the live view window, and
right click or click Stop Drawing to finish the area drawing.
- Click Select All to select the whole live view window as the configured area.
- Click Clear to clear the current drawn area.
4. Configure the parameters for the drawn area.
Uploading Data Type
Dwell Time
It refers to the target's dwelling time in the detection area.
Dwell Time and People Number
It refers to the target's dwelling time in the detection area and the people number in the
detection area.
Expected Number of People
It refers to the max. number of people for heat map counting.
ON
It refers to that the camera will compare the max. number of the people in the actual
scene with the set expected number of people and take the larger one as the max.
number of people for heat map.
OFF
It refers to that the camera will take the actual number of people as the max. value of heat
map.
5. Go to Arming Schedule tab, and click-and-drag the mouse on the time bar to set the arming
schedule. For the arming schedule settings, refer to Set Arming Schedule .
6. Go to Linkage Method tab, and select the linkage method by checking the checkbox of notify
the surveillance center. For the linkage settings, refer to Linkage Method Settings .
7. Click Save.
What to do next
The heat map statistics will be calculated under Application tab. Go to Application to check the
heat map statistics.
Network Camera User Manual
80
Advertisement
Table of Contents
