HIKVISION DS-2CD3956G2-IS(U) User Manual page 53

Steps
1. Select normal mode in Configuration.
2. Set the sensitivity of normal mode. The higher the value of sensitivity is, the more sensitive the
motion detection is. If the sensitivity is set to 0, motion detection and dynamic analysis do not
take effect.
3. Click Draw Area. Click and drag the mouse on the live video, and then right click the mouse to
finish drawing one area.
Clear Clear the selected area.
Clear All Clear all the areas.
4. Optional: You can set the parameters of multiple areas by repeating the above steps.
Set Video Tampering Alarm
When the configured area is covered and cannot be monitored normally, the alarm is triggered and
the device takes certain alarm response actions.
Steps
1. Go to Configuration → Event → Basic Event → Video Tampering .
2. Check Enable.
3. Set the Sensitivity. The higher the value is, the easier to detect the area covering.
4. Click Draw Area and drag the mouse in the live view to draw the area.
Stop Drawing Finish drawing.
Clear All
Network Camera User Manual
Delete all the drawn areas.
45