Table of Contents
Advertisement
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email server.
If you check the Enable STARTTLS while the protocol is not supported by your email sever,
your email is sent with no encryption.
4) Optional: If you want to receive notification with alarm pictures, check Attached Image. The
notification email has 3 attached alarm pictures about the event with configurable image
capturing interval.
5) Input the receiver's information, including the receiver's name and address.
6) Click Test to see if the function is well configured.
3. Click Save.
Notify Surveillance Center
Check Notify Surveillance Center, the alarm information is uploaded to the surveillance center
when an alarm event is detected.
Trigger Recording
Check Trigger Recording, and the device records the video about the detected alarm event.
For recording settings, refer to Video Recording and Picture Capture .
Flashing Light
After enabling Flashing Light and setting the Flashing Light Alarm Output, the light flashes when
an alarm event is detected.
Set Flashing Alarm Light Output
When events occur, the flashing light on the device can be triggered as an alarm.
Steps
1. Go to Configuration → Event → Basic Event → Flashing Alarm Light Output .
2. Set Flashing Duration, Flashing Frequency and Brightness.
Flashing Duration
The time that the flashing lasts when one alarm happens.
Flashing Frequency
The rate at which the light flashes. High frequency, medium frequency, low frequency, and
normally on are selectable.
Brightness
The brightness of the light.
Network Camera User Manual
62
Advertisement
Table of Contents
