Table of Contents
Advertisement
Network Camera User Manual
Steps
1. Check Enable.
2. Select and configure the corresponding time period and the scene.
Note
For the scene configuration, refer to Scene Mode .
3. Click Save.
Video Standard
Video standard is an ability of a video card or video display device that defines the amount of
colors that are shown and the resolution. The two most common video standard used are NTSC
and PAL. In NTSC, 30 frames are transmitted each second. Each frame is made up of 525 individual
scan lines. In PAL, 25 frames are transmitted each second. Each frame is made up of 625 individual
scan lines. Select video signal standard according to the video system in your country/region.
Local Video Output
If the device is equipped with video output interfaces, such as BNC, CVBS, HDMI, and SDI, you can
preview the live image directly by connecting the device to a monitor screen.
Select the output mode as ON/OFF to control the output.
Angle Between Cutting Line and Horizontal Radius
When you select a display mode of 180 or 360-degree panorama view in the hardware decoding
mode, you can adjust the angle between the cutting line and horizontal radius to obtain a desired
live view of a specific target. The live view changes according to the angle you set.
180-degree Panorama View
You can select an angle from 0°, 30°, 60°, 90°, 120°, and 180°. Take a 30° angle as an example, the
live view changes as follows:
31
Advertisement
Table of Contents
