Table of Contents
Advertisement
HARDWARE INSTALLATION
CyberPower Extended Battery Module (EBM) can be installed in a rackmount or vertical/tower
orientation. This versatility is especially important to growing organizations with changing needs
that value having the option to position an EBM on the floor or in a rackmount system. Note that
the included rack mounting hardware is only compatible with square hole racks. Please follow the
instructions below for the respective mounting methods.
RACKMOUNT INSTALLATION FOR 4-POST RACK
Caution: Important Instructions
To prevent the risk of fire or electric shock, only use the supplied hardware to attach the mounting
brackets.
Step 1: Remove the dust covers
Remove ten dust covers from the screw holes as shown below.
Step 2: Rackmount ear & hanging bracket installation
Attach two rackmount ears to the EBM using eight black M5X7L flat head screws and tighten two hanging
brackets using six silver M5X6L pan head screws.
1
2
Step 3: Rackmount rail Installation
The mounting depth of the included rackmount rails can adjust from 20.5 in to 36 in (52 cm to 91.5
cm). Select the proper holes in the rack for positioning the EBM in the rack. The EBM takes up 2
rack units: rack hole positions 1 through 6.
Position the guide screws on the back of the rackmount rails into the rear rack square holes to
temporarily support the rails in place.
Step 4: Adjust rackmount rails to fit your rack
Adjust the rail depth to match your rack depth. Attach each rackmount rail to your rack with two
black M5X 8 L pan head screws and two plastic washers at the front of the rack (square holes 1 and
4 as shown below). Secure each rail to the rear of the rack with two black M5X8L pan head screws
and two plastic washers
7
©2022 Cyber Power Systems, Inc. All rights reserved.
Advertisement
Table of Contents
