Table of Contents
Advertisement
EXTENDED BATTERY MODULE
INSTALLATION CONT.
CONNECTION WITH UPS
Scenario #1: UPS with one Extended Battery Module (EBM)
Step 1: Turn off the DC breaker on the EBM.
Step 2: Loosen the two screws to remove the battery cable retention bracket of the UPS.
Step 3: Use the output cable of the EBM to connect the EBM to the UPS.
1
OFF
Step 4: Rotate the battery cable retention bracket and tighten the two screws to fix battery cable.
Step 5: Connect the BM/ENV port from UPS rear panel to BM port marked "IN" on the rear panel of
the Extended Battery Module using the provided BM cable. Refer to illustration below.
Step 6: Connect the BMP connector from UPS rear panel to left side BMP connector on the rear
panel of the Extended Battery Module using the provided BMP cable. Refer to illustration below.
Step 7: Use a Schuko plug to IEC-320-C13 power cord to plug AC input inlet of the battery module
into a wall receptacle.
Step 8: Turn on the DC breaker of the EBM.
4
5
BM / ENV
Plug into a wall receptacle
2
6
BM
IN
OUT
©2022 Cyber Power Systems, Inc. All rights reserved.
7
PLUG INTO
A WALL
RECEPTACLE
3
8
ON
4
Advertisement
Table of Contents
