Advertisement
Operating Guide ECL Comfort 120 controller and app
2.4 Operating the ECL 120 with an app
To operate the ECL 120 with an app the operator must install a
dedicated application named ECL GO which can be linked from the
QR code presented to the right.
The application language is dependent on the mobile phone or
tablet operating system language. If the language is not supported
by the application, it will be presented in English.
ECL GO can be downloaded by scanning the QR code.
The application is intuitive and will guide the user to connect and
operate the ECL Comfort 120 controller.
The distance between the controller and operator's mobile
device / tablet should be less than 1,5 m to get good wireless
communication. Any metal obstacles in between will interfere the
signal.
After the application is downloaded and installed on the smart
device the operator must start commissioning the controller.
Bluetooth on the smart device should be activated.
To start the application press the icon of the ECL GO and the menu
of connecting to device is shown. Before searching the ECL 120
controller must be put to pairing mode according to the guide
(mobile phone pairing). From the smart device the controller is
scanned and all available controllers are displayed. The user selects
the ECL to be connected.
The application guides the user through the commissioning
procedure with general settings to select floor or radiator settings.
Default settings are already uploaded based on the selected type
of heating.
The next procedure is to select the basis for the flow temperature
control which is based on the room sensor, weather compensation,
primary supply or fixed reference. External input is supposed to
be used like heating master or thermostat. Within the next steps
connected components are displayed and correct wiring is done.
After finishing commissioning a report of the set-up can be
prepared and saved.
Guide on the functions in the app can be found in the ECL GO app.
2.4.1 Home menu icon on ECL GO
The home menu shows and guides the user to the basic functions
which are positioned on the top and bottom display.
•
Four different modes are displayed and selection can be made
between Automatic, Comfort, Saving and Frost protection.
•
On the bottom there is a menu to select between Home, Alerts,
Week or Schedule, and general settings are represented with
three dots and More.
AQ428842090782en-010102
Downloading app to smart device
QR code for Android/IOS
© Danfoss | 2022.12 | 9
Advertisement
