Appendix D: Using At Commands With The Speakerphone Feature; Turning On The Speakerphone Feature - Zoom ComStar XT SVD Owner's Manual

Appendix D: Using AT Commands with the
Speakerphone Feature
If you are familiar with the use of AT commands to control your
faxmodem, you can develop customized ways of using the
faxmodem's features that your communications software may not
directly support.
We do not recommend that you use AT commands unless you
are familiar with them. It is possible to disable your faxmodem
inadvertently.
To use the speakerphone feature with AT commands, you must
first go to terminal mode. Once you are in terminal mode, you can
use the speakerphone feature by following the procedures
explained in this appendix.

Turning On The Speakerphone Feature

To use the speakerphone feature, you must first be in voice
mode. To do this:
In terminal mode, type AT#CLS=8 and press Enter.
Once you are in voice mode, you can turn on the
speakerphone feature:
In terminal mode, type AT#VLS=6 and press Enter.
To answer an incoming call,
In terminal mode, type ATA and press Enter.
To originate a call, you first must set the Ringback Never
Came timer to zero, and then dial a call:
In terminal mode, type AT#VRN=0 and press Enter.
In terminal mode, type AT18005551212 and press Enter. In
this example, you would be dialing the number 1 (800) 555-
1212.

Appendix D: Using AT Commands with the Speakerphone Feature

43