Step 4: Configuring Your V3 - Zoom V3 1612 Quick Start Manual

Step 4: Configuring Your V3

• If you have a Cable Modem, see Configuring the V3 for a
Cable Modem
• If you have a DSL Modem, see Configuring the V3 for a DSL
Modem.
Configuring the V3 for a Cable Modem
The V3 is set up by default to work with a cable modem, so
additional configuration is normally not required.
1 1 1 1
Go to your Web browser (i.e., Internet Explorer or Netscape
Navigator) and try to connect to a familiar Web address.
2 2 2 2
If you connect successfully, your installation is complete
and you're ready to browse the Web! Continue with Step 5:
Setting Up VoIP Service on page 10.
Configuring the V3 for a DSL Modem
1 1 1 1
Open the Zoom Configuration Manager.
You should have a Zoom icon on your desktop. You must
double-click this icon to open up the Zoom
Configuration Manager. (If you do not have an icon,
open your Web browser, type http://10.2.2.2 and press
Enter.)
2 2 2 2
Log into the Zoom Configuration Manager.
Type admin for the username and zoomvoip for the
password in lowercase letters. (You will need to use this
username and password each time you want to log into the
Zoom Configuration Manager.)
3 3 3 3
The Basic Setup page displays.
At Internet Connection Type, pull down the list of selections
and choose the type of DSL your provider uses. If you don't
know what type you have, read below.
7