Table of Contents
Advertisement
5 5 5 5
If you have an existing router, we recommend that you
replace the existing router with the V3, which has a built-in
router. If, however, you need to connect the V3 behind
another router, plug one end of the Ethernet cable into the
WAN port of the V3 and plug the other end into a LAN port
of the router.
6 6 6 6
If you have a wireless access point or are using a wireless
router as an access point, unplug if from your computer or
modem and plug it into one of the V3's LAN ports.
7 7 7 7
Connect the V3 to your computer. We recommend that you
use the Ethernet port if possible, because Ethernet provides a
more reliable connection.
Ethernet - Plug one end of the included Ethernet cable into
one of the V3's LAN ports (1, 2, 3, or 4) and plug the other
end into the computer's Ethernet port.
USB - Plug one end of the USB cable into the V3's USB port
and the other end into the computer's USB port.
Powering Up
To ensure that all the devices you just connected to the V3 install
correctly, you need to power up each device one at a time.
1 1 1 1
Plug in the modem's Power Supply, and turn on the
modem's on/off switch if it has one.
Plug the modem's power cube into a power outlet.
Wait for one-two minutes so that you are sure the modem has
completed its power up process before proceeding to Step 2.
2 2 2 2
Plug in the V3's Power Supply.
Plug the included power cube into a power outlet and then
into the V3's power (PWR) jack.
Wait for one-two minutes so that you are sure the V3 has
completed its power up process before proceeding to Step 3.
Note: Use only the power cube shipped with the V3 or you
may cause damage to your hardware.
5
Advertisement
Table of Contents
