Table of Contents
Advertisement
easily tell by the ring that you are receiving a VoIP call. Perhaps
more important, when you make a VoIP call, you will hear a
different dial tone than you hear on the public phone network, so
that you can be sure you are making a VoIP call.
Speed dialing - If the phone that you plugged into the V3 has a
speed dialing feature, you can use it for your VoIP calls and your
regular calls. Just be sure to start the VoIP calls with the # symbol
(except in VoIP Only Mode where you don't use the #).
Redial - You may redial a VoIP number just as you would redial
any other number, using the redial feature on your phone.
Hook Flash - If you receive a second call while you are on a VoIP
call, you will hear a call waiting tone. Momentarily press the hook
button on your phone to talk to the second caller, and press it
again to go back to your first conversation. After you have
completed a VoIP call, you can press the hook button to get a
fresh VoIP dial tone and make another VoIP call without dialing #
(Note that redial or speed dialing will not work in this case,
however. You must hang up for at least one second if you need to
make a conventional phone call.
Setting the V3 for VoIP Only Mode
For models outside of the US, the V3 can be set to operate in
VoIP Only Mode. Use VoIP Only Mode if:
You have a cable modem and you are not near a phone jack
•
that you can plug the V3 into.
•
You are using a DSL modem and your DSL line also provides
your ISDN service.
You are using "unbundled" DSL—that is, a line without any
•
telephone service attached to it.
•
You intend to use the phone connected to the V3 solely for
VoIP calls. That way, you do not have to hit # before every
call.
To put the V3 in VoIP Only Mode, follow these steps:
1 1 1 1
From the Zoom Configuration Manager, click the Voice
Over IP icon at the top of the page.
13
Advertisement
Table of Contents
