Installing the SRX340 Firewall in a Rack
You can front-mount the SRX340 Firewall in a rack. Many types of racks are acceptable, including four-
post (telco) racks, enclosed cabinets, and open-frame racks.
NOTE: If you are installing multiple devices in one rack, install the lowest one first and proceed
upward in the rack.
To install the services gateway in a rack:
1. Position a mounting bracket on each side of the chassis.
2. Use a number-2 Phillips (+) screwdriver to install the screws that secure the mounting brackets to the
chassis. Use either the front mount position, as shown in
position, as shown in
Figure 6: Installing the Rack Mount Brackets (Front Mount Position)
Figure 7: Installing the Rack Mount Brackets (Center Mount Position)
3. Have one person grasp the sides of the services gateway, lift it, and position it in the rack.
4. Align the bottom hole in each mounting bracket with a hole in each rack rail, making sure the chassis
is level.
5. Have a second person install a mounting screw into each of the two aligned holes.
Figure 7 on page
34.
Figure 6 on page
34, or the center mount
34