Table of Contents
Advertisement
Tiguan 2021 ➤, Tiguan RUS 2021 ➤
Brake system - Edition 10.2020
Installing:
Install in reverse order of removal, observing the following:
NOTICE
The brake servo is given the additional bonded joint only dur‐
ing factory assembly.
The adhesive bond between the brake servo and the bulk‐
head does not need to be renewed, but the seal does.
– Renew gasket between brake servo and bulkhead
(page 99)
.
– Carefully insert brake servo and tighten nuts hand-tight.
– When assembling brake master cylinder with brake servo,
make sure push rod is properly positioned in brake master
cylinder.
– When joining brake master cylinder to brake servo, make
sure seal
⇒ Item 10 (page 99)
– Ensure that seals
⇒ Item 17 (page 100)
in brake master cylinder.
– Coat sealing plugs with brake fluid before pressing brake
fluid reservoir into brake master cylinder.
Continued for all vehicles:
– Code brake servo control unit -J539- ⇒ Vehicle diagnostic
tester.
– Perform basic setting for electromechanical brake servo
⇒ Vehicle diagnostic tester.
Torque settings
♦
⇒ o3.1.2 verview – brake servo/brake master cylinder, right-
hand drive vehicles", page 98
♦ ⇒ General body repairs, interior; Rep. gr. 68; Compartments
and covers; Assembly overview – Dash panel cover on driv‐
er side
♦ ⇒ Heating, air conditioning; Rep. gr. 87; Air duct; Assembly
overview – air duct and air distribution in passenger com‐
partment
3.3
Removing and installing brake master
cylinder
⇒ a3.3.1 nd installing brake master cylinder, left-hand drive ve‐
hicles", page 106
⇒ a3.3.2 nd installing brake master cylinder, right-hand drive
vehicles", page 112
3.3.1
Removing and installing brake master
cylinder, left-hand drive vehicles
Special tools and workshop equipment required
106
Rep. gr.47 - Brakes - hydraulics
⇒ Item 7
is properly seated.
are correctly seated
GETtheMANUALS.org
Advertisement
Table of Contents
