Product Overview; Product Variants And Identification - Zepro ZS MK2 Technical Manual

Hide thumbs Also See for ZS MK2:

Table of Contents

Product overview

1.1

1.1.1

The type sign

Zepro offers a number of model families each consiting of a number of different variants with varying levels

of functionality. The control systems, hydraulic configurations, available control devices and sensors can

vary between models and even between variants of the same model. It is therefore crucial to always identify

the model and the variant before working on a tail lift. By first identifying the tail lift, the correct information

for that particular tail lift can be found.

The first step in the process of identifying the variant is locating the type sign and reading the information

in the tail lift type-field. The location of the typesign varies between different tail lift models but it is always

riveted onto the support frame of the lift, with the most common location being shown on the figure below.

There should also be a sticker showing the same information in the users manual and on the door sill on the

drivers side of the vehicle.

For the ZS MK2 models covered in this document, the following nomenclature is used. The "ZS" denotes the

model designation followed by the "Mk2" which denotes second generation design of the ZS product. "SLI"

stands for slimline, a configuration with a slightly different mounting brackets and motor/driveshaft location.

The four digit number denotes the capacity of the tail lift, in kilograms, and the three digit number that fol-

lows it denotes the maximum lifting height, in centimeters.

ZEPRO

Model

ZS-MK2

ZS-MK2 SLI

Capacity

1500

2000

2500

Lifting height

135

155

175

www.zepro.com

Table of Contents