Table of Contents
Advertisement
3. INSTALL / REPLACE THE CUTTERS
DRIVING CURVED PIPE:
Install BOTH 15mm and 16mm cutters as described.
Install the 16mm cutter FIRST (begin from step 3.1)
DRILLING FLAT FACE / SQUARE PIPE
Install the flat face spacer FIRST, before installing
the 16mm and 15mm cutters. See supplementary
guide: THETA 750 SNAP Drill Jig Flat Face Setup
(page 16).
NOTE!
Before installing cutters, engage your
drill on the Drill Jig's hex drive to extend the
cutter end (below left). The Drill Jig is ready for
cutter installation when the cutter end is FULLY
EXTENDED from the Drill Jig (below right).
Fig. 3.1 Use your drill to fully extend the cutter end
(above right) BEFORE cutter installation.
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
INSTALLING THE 16MM CUTTER
COUNTERBORE CUTTER:
3.1
Extend the Drill Jig's cutter end / thread using
your drill. Ensure to fully extend the cutter end
(Fig. 3.1).
3.2
On the 16mm cutter, ensure the cutter spacer
is carefully inserted into the cutting side of the
16mm cutter (see Drill Jig Parts).
3.3
Lightly screw the 16mm cutter onto the threaded
cutter end of the Drill Jig's cutter assembly.
3.4
Secure the 10mm wrench on the hex drive and
the cutter removal tool's 16mm end to the cutter
(Fig. 3.4)
3.5
While securing the spanner, rotate the cutter
removal tools lever clockwise to tighten the
cutter onto the cutter end of the Drill Jig until it is
firm and secure.
INSTALLING THE 15MM CUTTER:
3.6
Lightly screw the 15mm cutter onto the threaded
cutter end of the Drill Jig's cutter assembly.
3.7
Secure the 10mm wrench on the hex drive and
the cutter removal tool's 15mm end to the cutter.
3.8
While securing the wrench, use the cutter
removal tools lever to rotate the cutter clockwise
onto the cutter end of the shaft until it is
firmly secure.
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
REMOVING / REPLACING THE CUTTERS:
Ensure to fully EXTEND the cutter-end of the Drill
Jig before cutter removal. Proceed to reverse the
described steps for installing the 16mm and/or
15mm cutters. Use a counter-clockwise turn on the
cutter removal tool.
TIP!
Place the Drill Jig on a flat surface to make
cutter installation or removal easier.
Fig. 3.4 Use the cutter removal tool and wrench provided
to remove or secure the cutters. Note the cutter removal
tool's 15mm side (shallow) and 16mm side (deep).
Ledra Brands Inc.
88 Maxwell
F 714.259.9969
www.LedraBrands.com
Irvine, CA 92618
P 714.259.9959
8
Advertisement
Table of Contents
