Clamp Drill Jig To Rail - Ledra Brands THETA 750 SNAP Operating Instructions Manual

6. CLAMP DRILL JIG TO RAIL

6.1 REMINDER! Ensure you have applied cutting
lubricant to the cutter.
6.2 Align the Drill Jig's clamp body to the tape
position and wrap the clamping chain around
the rail. Engage the chain with the Drill Jig's
chain hook.
NOTE!
If rail is painted-protect the paintwork
from the clamp body/chain with a suitable tape
or cloth.
TIP! Open the vice grip handles fully to enable
easier engagement of the chain and chain hook.
6.3
Adjust the clamp tension as needed using the
handle's tension thumb screw.
6.4 Adjust the rotation of the clamp body until the
angles setter's level indicator is centered.
6.5 Squeeze the vice grip handles together to lock
the Drill Jig in position. Check that the clamp
body is firmly secure on the rail with no lateral
movement, and confirm that the alignment and
level is still correct.
NOTE! Ensure the clamping chain is in a
central position and that it is not touching the
cutter assembly or the vice grip once the grip
is engaged. If it is touching, tension may be too
loose. Adjust the tension (see step 6.3).
TIP! Once the correct clamp position/tensioning
has been achieved, mark the chain with
permanent marker as a reminder of where to
engage the chain.
TIP! The Drill Jig can be rotated/reversed 180°
to enable a second clamping orientation. Choose
the appropriate orientation to prevent interference
with vertical rail poles. Note, if reversing the Drill
Jig in position, the angles setter must be adjusted
to opposite axis/negative position (see step 4).
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
Fig. 6.2 - 6.5 Align clamp body with the tape and engage the chain hook and clamping chain. Ensure the level bubble remains centered.
Above: The clamping chain is secure, in a central position, and is not touching
the engaged vice grip or the central section of the cutter assembly.
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
Adjust tension to ensure the clamp body is secure on the rail.
Ledra Brands Inc. 88 Maxwell F 714.259.9969
www.LedraBrands.com Irvine, CA 92618 P 714.259.9959
Adjust tension
as needed
11