Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
ISSUE
SOLUTION
The drill spins when reversing/
The hex drive is not disengaging
the Drill Jig hex drive does not
from the cutters. To resolve,
retract when reversing and
offset the angle of the drill
appears stuck.
slightly (1-2°) while reversing.
The hex drive should now
disengaging and retract.
The cutters do not cut/takes a
1. Confirm a slug is not
long time to cut.
present/stuck inside the
cutter assembly.
2. The cutters may be blunt.
Refer to Install/Replace the
Cutters (step 3).
Shaving coloring
1. The Drill speed (RPM) is too
appears unusual.
high. Lower the drill speed.
2. There is not enough
lubrication on the cutters.
Lubricate the cutters (step 5)
3. The cutters are blunt/
damaged. Replace the
cutters (step 3).
NOTE!
If you have an issue that is not identified/resolved here,
please contact your supplier or Ledra Brands for support
DO NOT
attempt to modify the Drill Jig or operate it outside of the
range described within this manual. If the Drill Jig is not functioning
as expected please contact Ledra Brands ASAP at (714) 259-9959.
Do not attempt to modify the drill jig or operate it
outside of the range described within this manual.
Contact ledrabrands ASAP if the drill jig is not operating
as expected.
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
DRILL JIG FLAT FACE SET UP
THE FLAT FACE SPACER
Square pipe/flat-faced rail applications require a spacer fitted inside
the Drill Jig.
The Drill Jig should come pre-fitted with the required spacer, however
be sure to confirm it is installed, and to reinstall it as described when
removing/replacing the cutters.
INSTALLING THE FLAT FACE SPACER
1. The Drill Jig cutter assembly is ready for installing the spacer when
there are NO cutters and the cutter end is FULLY EXTENDED (see
Removing the Cutters in step 3).
2. Simply insert the flat face spacer (tapered end first, as pictured) into
the back of the Drill Jig's cutter assembly.
3. Continue with installing the cutters. Refer to Install/Replace the
Cutters (step 3 in this manual).
3
2
15mm cutter
16mm cutter
(with cutter
spacer)
The flat face spacer is installed FIRST, followed by the cutter installation (see
step 3). Remember to fully extend the cutter end of the Drill Jig (as shown).
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
1
flat face
spacer
Ledra Brands Inc.
88 Maxwell
F 714.259.9969
www.LedraBrands.com
Irvine, CA 92618
P 714.259.9959
Above : the flat face spacer.
Flat face (square) rail applications
require the flat face spacer installed in
the Drill Jig.
15
Advertisement
Table of Contents
