Remove Drill Jig And Clean - Ledra Brands THETA 750 SNAP Operating Instructions Manual

9. REMOVE DRILL JIG AND CLEAN

9.1 Open the vice grip and disengage the clamping
chain to remove the Drill Jig from the rail.
9.2 Inspect inside the cutter assembly for presence
of a slug. If present, REMOVE the slug from the
cutter with pliers (Fig 9.2).
9.3
Remove any shavings around the cutters with
the supplied pliers. Shake out any remaining
shavings. Do NOT use compressed air to clean.
9.4
File the hole with the supplied file to remove
burrs. Wipe rail clean with a cloth.
9.5 Go to the next hole and repeat from step 5.
NOTE! Check that you have removed the slug
after EACH hole drilled. If the slug is stuck, use
pliers to remove.
NOTE! Be sure to collect shavings and other
waste from the site and dispose responsibly.
TIP! A good time to lubricate the cutters for
the next hole is just AFTER cleaning the
cutter assembly.
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
After drilling EACH hole, inspect the cutter assembly. Check for a slug
and shaving build up (present in the above image).
Slug and shavings can be hot enough to burn And injure.
Use appropriate personal protective Equipment (PPE)
such as goggles, gloves, and Safety boots.
Do not clean the cutter assembly with compressed air. This
may cause shavings to be wedged between components,
causing issues.
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
Fig 9.2 IMPORTANT! REMOVE the slug and shavings with pliers.
Ensure to inspect the cutters and remove the slug after each
hole is drilled.
Ledra Brands Inc. 88 Maxwell F 714.259.9969
www.LedraBrands.com Irvine, CA 92618 P 714.259.9959
14