How The Drill Jig Works - Ledra Brands THETA 750 SNAP Operating Instructions Manual

HOW THE DRILL JIG WORKS

WHAT IS THE THETA 750 SNAP DRILL JIG
The THETA 750 SNAP Drill Jig's purpose is to
enable consistent and accurate drilling of metal
pipe, with counterbore, and to significantly reduce
installation time.
The THETA 750 SNAP Drill Jig is designed for the
following:
– Use with a battery-operated (cordless) drill ONLY
– Installing the latest generation LED Puck Snap-
type modules ONLY: Snap, Solo, Zero, RGBW,
Wide and IP68
– Use with curved-face metal rail, or flat faced rail
(spacer fitting required for flat faced-rail, see note*)
– Cutting a hole with a 15mm diameter and a 16mm
counterbore. See Minimum Wall Thickness table.
THE DRILL JIG IN USE
Operating a drill attached to the THETA 750 SNAP
Drill Jig will automatically drive its cutters into the
cutting surface until full depth is achieved and the
hole fully made. The Drill Jig will automatically cut
the counterbore hole. Once cutting is achieved,
reversing the drill will withdraw the cutters back
inside the Drill Jig cutter assembly and into a
position ready for the next hole.
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
MINIMUM WALL THICKNESS
Observe the Drill Jig / Puck requirements for
LED
minimum wall thickness.
MINIMUM THICKNESS
RAIL TYPE
CURVED FACE (TUBE) 1.5mm
2.0mm
CURVED FACE (TUBE)
Table 1. Minimum wall thickness for different rail types.
Contact LEDRAbrands or your distributor if your specifications
are outside these minimums. *See Flat Face note below.
*See flat face rail note
(right)
Curved Face (Tube) Rail Flat Face (Square) Rail
COUNTER-BORING
To ensure counter-boring works as intended, make
sure that your 15mm and 16mm cutter installation is
correct (step 3). The result should be the
LED
embedded flush within the rail (below).
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
Above: The THETA 750 SNAP Drill Jig in use. Proper use
of the Drill Jig will result in a significantly faster and more
professional finish.
TIP!
Test your first hole on a spare piece of pipe
and spare
LED
*NOTE!
Square pipe / flat-faced rail applications
Puck
require a spacer fitted to the Drill Jig. Refer to the
supplementary document: THETA 750 SNAP Drill
Jig Flat Face Setup (page 16).
Ledra Brands Inc. 88 Maxwell
www.LedraBrands.com Irvine, CA 92618
Puck.
F 714.259.9969
P 714.259.9959
5