Inspect The Cutter Assembly - Ledra Brands THETA 750 SNAP Operating Instructions Manual

2. INSPECT THE CUTTER ASSEMBLY

The cutters are installed and ready for use in your
Drill Jig. Inspect inside the cutter assembly and
follow the appropriate steps to confirm your setup:
CUTTERS ARE INSTALLED
2.1
Ensure that the cutter end is fully retracted
inside the cutter assembly. If not, reverse the
cutter into the assembly by engaging the drill
(reverse) on the Drill Jig hex drive (Fig 2.1)
The cutters should NOT protrude from the
cutter assembly
CUTTERS ARE NOT INSTALLED
2.2 If cutters are not yet installed (Fig. 2.2), proceed
to install them as shown in step 3.
NOTE! Check if a flat face spacer is present
inside the cutter assembly. ONLY use the spacer
if drilling square/flat-face pipe. Refer to THETA
750 SNAP Drill Jig Flat Face Setup.
flat face spacer
The flat face spacer is
used with square pipe ONLY
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
Fig. 2.1 If cutters are pre-installed, use your drill to
ensure that both the hex drive and cutter end of the cutter
assembly are fully retracted.
Fig. 2.2 Cutter end of the cutter assembly pictured
above. The cutters are not yet installed. Proceed to cutter
installation (step 3).
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
✓
CORRECT. Cutters are installed and fully retracted inside
the cutter assembly.
✗
INCORRECT. Installed cutters should NOT remain
protruding from the cutter assembly. Ensure that cutters
are fully retracted inside the cutter assembly before using
the Drill Jig.
Ledra Brands Inc. 88 Maxwell F 714.259.9969
www.LedraBrands.com Irvine, CA 92618 P 714.259.9959
7