Drill The Hole - Ledra Brands THETA 750 SNAP Operating Instructions Manual

8. DRILL THE HOLE

8.1 Connect the drill's 10mm nut driver (female) to
the matching (male) hex drive on the Drill Jig
(Fig. 8.1)
8.2 Engage the drill. DON NOT FORCE OR PUSH
THE DRILL. Use light pressure to keep the
socket engaged. STOP DRILLING once the hex
drive has fully receded into the cutter assembly
(Fig. 8.2).
NOTE! The resistance will vary during the cut as
the cutters penetrate the metal. This is normal.
8.3 Switch the drill to REVERSE, and engage the
drill to back out the cutters. Ensure the hex
drive is fully retracted from the cutter assembly
(Fig. 8.3).
NOTE! When reversing, if the drill spins and/or
the hex driver does not retract, offset the angle of
the drill slightly 1-2° while reversing. The drill and
hex driver should now reverse.
NOTE! Ensure your drill battery us charged/
changed as needed as this will keep drill times
efficient and the Drill Jig operating effectively.
v.2.14.24
THETA750 SNAP Drill JIG Instruction Sheet
Fig 8.1 Do NOT force/push the drill. Use light pressure only to keep the
socket engaged.
Fig 8.3 Set drill to reverse and back out the cutters / hex drive until it is
fully retracted.
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
Fig 8.2 STOP drilling once the hex drive has fully receded inside the Drill Jig.
hex drive
fully RETRACTED
Ledra Brands Inc. 88 Maxwell
www.LedraBrands.com Irvine, CA 92618
hex drive
fully RECEDED
F 714.259.9969
P 714.259.9959
13