Package Checklist For Hotwire Model 7925-A1; Connecting To The Network - Paradyne HotWire 7925 User Manual

Installing the Unit

Package Checklist for HotWire Model 7925-A1

Verify that your package contains the following:

Connecting to the Network

Procedure
7925-A2-GB20-30
PRELIMINARY DRAFT
A HotWire Model 7925-A1 standalone unit
VT100 Terminal Cable
A 14 twisted pair network cable
Power cord with power transformer (optional)
Warranty card
V.35-compatible units only: a ferrite bead for RFI suppression
1. Connect one end of the supplied 14 twisted-pair network cable into the rear
panel HDSL jack. Connect the other end to your HDSL network interface.
NOTE:
Do not use a flat VF network cable, as this may severely degrade the
performance of the termination unit. Use only twisted-pair network cable.
2. V.35-compatible units only: Clamp the supplied ferrite bead around your V.35
cable, one inch from the end that plugs into the V.35 connector on the
HotWire unit. This bead suppresses RF interference and is required to meet
compliance standards.
3. Connect a V.35- or G.703-interface cable into the appropriate connector on
the rear panel. Connect the other end to your V.35 or G.703 equipment.
June 1997
2
2-1