Making Changes From The Terminal Interface; Making Changes In Switchpack Mode - Paradyne HotWire 7925 User Manual

Customizing G.703-Compatible Units
This guide depicts the system terminal menus as they appear from a unit
configured for use on the CP side of an HDSL connection. This is the default
configuration for Model 7925-A1 units. The Main menu for a unit configured for
use on the CO side is identical, except that option 8 is HTUR Menu.

Making Changes from the Terminal Interface

The Board Configuration menu displays the current board software and hardware
settings. It also allows you to change certain parameters on the board.
This function is affected by the status of the switchpack (DIP switch control)
setting.
From the Main Menu, select option 4, Board Configuration.
4-2
The "G123" code indicates the unit powered up successfully.
Enter "?" to redisplay the menu.
Option 3, Channel Blocking, is not available in this release.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switchpacks and jumpers on the board hardware. Refer to

Making Changes in Switchpack Mode

Command 4
Board Configuration:
1) HDSL Card Type
HDSL Rate Type
2) Loops Enabled
3) E1 Line Encode
4) Framing
5) Line Build Out
HDSL FW Rev
AT+T FW Rev
CP Serial #
–––––––––––––––––––––––––––––––––––––––––––––––––––––––
1–5) Board Configuration
6) Switchpack Definitions
7) Line Build–Out Definitions
?) Prints Board Configuration and this menu
Q) Quit
Config
June 1997
on page 4-5.
– CP
– E1
– Dual Loop (Loops A and B)
– HDB3
– Framed
– 75 ohm termination
– 06
– 1.17
– 086074
7925-A2-GB20-30
PRELIMINARY DRAFT