Installation Instructions Document Number 6390-A2-GN10-10 October 2002 Package Checklist Verify that your package contains the following: DSL interface cable Hotwire 6390 Power cord with ReachDSL Modem with RJ11 connectors power transformer Wiring and Cables You May Need (not supplied) The following standard cables and connectors can be used with this product:...
Installing Additional Phone Filters A phone filter is recommended to minimize background noise during a phone conversation on telephones not connected directly to the Hotwire 6390 ReachDSL Modem. If additional telephones in your home or business share the same phone line with the ReachDSL modem, install one phone filter on each telephone.
Page 3
Installing the Hotwire 6390 ReachDSL Modem Place the Hotwire 6390 ReachDSL Modem on a flat surface with clearance for the rear connectors. Procedure UNPLUG TELEPHONE. If a telephone is connected at the RJ11 wall jack where the ReachDSL modem will be installed, unplug the telephone line from the wall jack.
The ReachDSL modem hardware installation is now complete. For More Information For more information about the Hotwire 6390 ReachDSL Modem, including front panel LED status, troubleshooting, cabling, command line interface, downloading, and technical specifications, please refer to the Inline Phone Filter, Installation and Operation Number 6390-A2-GK40.
Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the product and to protect it from overheating, these slots and openings must not be blocked or covered. 3.
Japan – Notices This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.
Supplier’s Declaration of Conformity Place of Issue: Paradyne Corporation 8545 126 Largo, FL 33773-1502 Date of Issue: 10/17/2002 Paradyne Corporation, located at the above address, hereby certifies that the Hotwire Number 6390-AX-210, bearing labeling identification number US:AW2DL03B6390-AX complies with: the Federal Communications Commission’s (“FCC”) Rules and Regulations 47 CFR Part 68, the Administrative Council on Terminal Attachments (“ACTA”)-adopted technical criteria TIA/EIA/IS-968, “Telecommunications –...
If the site has specially wired alarm equipment connected to the telephone line, ensure the installation of the ReachDSL™ Modem does not disable the alarm equipment. If you have questions about what will disable alarm equipment, consult your Telephone Company or a qualified installer. Notice to Users of the Canadian Telephone Network NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications.