Table of Contents
Advertisement
19. Use only the power cord indicated in this manual.
20. For pluggable equipment, the socket-outlet (power adapter) shall be
installed near the equipment and shall be easily accessible.
21. In wall mounting position, make sure to mount the telephone base on the
wall by aligning the eyelets with the mounting studs of the wall plate. Then
slide the telephone base down on both mounting studs until it locks into
place. Mount the device only at heights not exceeding 2 meters. Refer to the
full installation instructions in the User Manual.
22. CAUTION: Keep small metallic objects such as pins and staples away from
the handset receiver.
23. WARNING: The product included (ITE) in this manual is to be connected
only to PoE networks without routing to the outside plant.
SAVE THESE INSTRUCTIONS
Power requirements
CAUTIONS:
•
Use only the power adapter provided with the product.
•
Use only the supplied rechargeable battery or replacement battery (model:
573554).
•
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
•
Avoid using battery in the following conditions:
• High or low extreme temperatures that a battery can be subjected to
during use, storage or transportation;
• Replacement of a battery with an incorrect type that can defeat a
safeguard;
• Disposal of a battery into fire or a hot oven, or mechanically crushing or
cutting of a battery, that can result in an explosion;
• Leaving a battery in an extremely high temperature surrounding
Handset charger power adapter:
Input: 100-240V AC 50/60Hz 0.3A, Output:
5VDC 2A (Model number: NBS10B050200VUU,
Manufacturer: Mass Power)
Handset battery: 3.7V 1350mAh, Li-ion Polymer
battery (Model number: 573554, Manufacturer:
Shenzhen EPT Battery Co., Ltd.)
4
Advertisement
Table of Contents
