Snom M56 Quick Installation Manual page 23

Manually registering via the LINK key on base station
1. Make sure the base station is connected to power and the network.
NOTE: If your phone system is a dual-cell environment, you can only register
the handset to the Primary base station (as indicated by a steady green or
slowly flashing red
2. If the handset is displaying the following screen:
3. On the "Device not registered to base station." screen, press Reg.
4. With LINK key on Base highlighted, press Sel.
The handet displays the following screens (press Next or Back):
5. Press and hold the LINK key on the base station for four seconds.
The (power) and
6. Press the # key on the handset to begin registration.
The handset displays "Registering... Please Wait."
If registration is successful:
The handset beeps and displays "Handset Registered", and
then displays the idle screen.
If registration fails:
The handset beeps and displays "Registration failed".
a. Press OK.
The handset displays "Device not registered to base station."
b. Make sure the handset is near the base station.
c. If your phone system is a dual-cell environment, make sure you are
registering to the Primary base station. The
either steady green or slowly flashing red.
d. Try to register again; go to step 3.
SIP LED).
a. Press Cancel.
The handset displays "Registration failed".
b. Press OK.
The handset displays "Device not registered to base
station."
(SIP) LEDs flash green.
23
SIP LED should be