Snom M56 Quick Installation Manual page 24

Manually registering via the Web UI
1. Make sure the base station is connected to power and the network.
2. If the handset is displaying the following screen:
3. On the "Device not registered to base station." screen, press Reg.
4. Press
or
The handet displays the following screens (press Next or Back):
5. Using the base station's IP address, open the base station's WebUI in a web
browser.
NOTE: If your phone system is a dual-cell environment, you must open
the WebUI of the Primary base station. To check, click Status in the WebUI
sidebar, and then click Base Status. See which base station IP address is set
to "Primary" mode. Open the WebUI for this IP address.
6. On the WebUI, click Status and then click Cordless Registrations.
7. Under Manual registration, click Start.
The WebUI displays "Success / Registration started".
8. Press the # key on the handset to begin registration.
The handset displays "Registering... Please Wait."
If registration is successful:
The handset beeps and displays "Handset Registered", and
then displays the idle screen.
If registration fails:
The handset beeps and displays "Registration failed".
a. Press OK.
The handset displays "Device not registered to base station."
a. Press Cancel.
The handset displays "Registration failed".
b. Press OK.
The handset displays "Device not registered to base
station."
to scroll to Manual start on WUI and press Sel.
24