Wall mounting the charger
The charger is ready for tabletop use. If you want to mount the charger on a wall,
use two 19 mm (3/4 inch) screws and wall anchors to hold the charger in place.
Screws and wall anchors are not provided, but are available for purchase at
hardware retailers. You might need a professional to install the charger. You will
also need an L-shaped USB-C converter (sold separately) to connect the charger
to the charging cable. To order this converter, visit our website at
www.snomamericas.com
To mount the charger on the wall:
1. Use a pencil to mark the desired positions of the two holes on the wall. Make
sure the space between the two holes is 32 mm (1 1/4 inches).
Drill two holes in the wall according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a
stud, insert the wall anchors into the holes and
tap gently on the ends with a hammer until the
wall anchors are flush with the wall.
3. Insert the screws into the holes and tighten them
until only 6 mm (1/4 inch) of the screws are
exposed.
4. Align the holes at the back of the charger with the
screws on the wall and slide the charger down
until it locks into place.
.
20
Mount the device
only at heights not
exceeding 2 meters
(79 inches).