Advertisement
MOUNTINGS AND CONNECTIONS
Packing
The burners are despatched in cardboard packages of dimensions::
G4..S
G4..L
G6
G10..S - G18..S
G10..L - G18..L
Packing cases of this type are affected by humidity and are not suitable for stacking.
The following are placed in each packing case:
1 burner;
2 flexible light oil tubes;
1 filter;
1 gasket to be inserted between the burner and the boiler;
1 this manual.
When disposing of the burner packing and if the packing is scrapped follow the procedures laid down in the current legislation
regarding the disposal of materials.
Fitting the burner to the boiler
Fix the flange of the burner to the boiler as shown in Fig. 4.
This allow a correct inclination towards the combustion cham-
ber. If necessary, after fitting the burner to the boiler, seal the
space between the blast tube and the refractory lining with
appropriate insulating material (ceramic fibre cord or refractory
cement).
Electrical connections diagram
Remove the burner's housing;
make the electrical connections following the schemes in Fig. 5a and Fig. 5b;
refit the burner's housing.
Only G4 G-.TN.x.xx.S.x
RESPECT THE BASIC SAFETY RULES. MAKE SURE OF THE CONNECTION TO THE EARTHING SYSTEM. DO NOT
REVERSE THE PHASE AND NEUTRAL CONNECTIONS. FIT A DIFFERENTIAL THERMAL MAGNET SWITCH
6
330 - 320 - 300 mm (H x W x D)
390 - 320 - 300 mm (H x W x D)
360 - 300 - 450 mm (H x W x D)
420 - 350 - 420 mm (H x W x D)
420 - 350 - 620 mm (H x W x D)
Fig. 5a
ADEQUATE FOR CONNECTION TO THE MAINS.
PART I: INSTALLATION MANUAL
Fig. 4
All models excluded G4 G-.TN.x.xx.S.x
Fig. 5b
Advertisement
